Description
Technical Parameters
Product Introduction
Power Supply IC695PSD140 is a multi-purpose 40-Watt supply that operates from an input voltage source in the range of 18 VDC to 30VDC. The Power Supply indicates when an internal fault occurs, allowing the CPU to detect a loss of power or log the corresponding fault code.
Technical Specifications
|
Manufacture |
GE Fanuc
|
|
Model |
IC695PSD140 |
| Part Number | IC695PSD140 |
|
Description |
RX3I Multipurpose Power Supply |
|
Origin |
USA |
|
Dimension |
25*20*8cm |
|
Weight |
0.85kg |
Product Details
This power supply IC695PSD140 provides three outputs:
▪ +5.1 VDC output
▪ +24 VDC relay output that can be used to power circuits on Output Relay modules
▪ +3.3 VDC. This output is used internally by RX3i modules with IC695 catalog numbers
Multipurpose Power Supply IC695PSD140 is suitable for use in load sharing and redundancy applications. It must be installed in a PACSystems RX3i (IC695 catalog number) Universal Backplane. It can be used as the only power supply in the backplane or combined with up to three additional Multipurpose Power Supplies.
This Power Supply cannot be used with RX3i IC695PSD040 or IC695PSA040 Power Supplies in redundant or increased capacity modes. Damage to equipment may result.
Four LEDs on the Power Supply indicate:▪ Power (Green/Amber). When this LED is green, it indicates power is being supplied to the backplane. When this LED is amber, power is applied to the Power Supply, but the Power Supply switch is off.
▪ P/S Fault (Red). When this LED is lit, it indicates the Power Supply has failed and is no longer supplying sufficient voltage to the backplane.
▪ Over Temperature (Amber). When this LED is lit, it indicates the Power Supply is near or exceeding its maximum operating temperature.
▪ Overload (Amber). When this LED is lit, it indicates the Power Supply is near or exceeding its maximum output capability on at least one of its outputs.
If the red P/S FAULT LED is lit, the Power Supply has failed and is no longer supplying sufficient voltage to the backplane.
The amber OVERTEMP and OVERLOAD LEDs light to warn of high temperature or high load conditions. The CPU Fault Table shows a fault if any Overtemperature, Overload, or P/S Fault occurs.
Terminals for +24V and 24V power, ground, and MOV disconnect accept individual 14 to 22 AWG wires.
The ON/OFF switch is located behind the door on the front of the module. The switch controls the operation of the outputs of the supply. It does NOT interrupt line power. A projecting tab next to the switch helps prevent accidentally turning it on or off.