Product Introduction
Technical Specifications
|
Manufacture |
General Electric(GE) |
|
Model |
IC698ETM001 |
| Part Number | IC698ETM001 |
|
Description |
PACSystems™ RX7I Ethernet Module |
|
Origin |
USA |
|
Dimension |
30*20*5cm |
|
Weight |
0.5kg |
Product Details
IC698ETM001 Ethernet Interface module provides:
− Data exchange using Ethernet Global Data (EGD)
− TCP/IP communication services using SRTP
− Full control system programming and configuration services
− Comprehensive station management and diagnostic tools
− Two full-duplex 10BaseT/100BaseT/TX (RJ-45 Connector) ports with an internal network switch providing auto-negotiated network speed, duplex mode, and crossover detection.
Hardware Identification：
The following table shows the revision level of the circuit boards used in the initial release of the RX7i Ethernet Interface Module.
| Catalog Number | Circuit Board ID |
| IC698ETM001-AA Carrier Card | NE8A1 |
| IC698ETM001-AA Ethernet | EX8A1 |
Firmware Identification：
| Catalog Number | Ethernet Firmware Revision |
| IC698ETM001-AA |
Main: 1.00 (21A1) Boot: 1.00 (21A1) |
The PACSystems RX7i provides direct connection to one or two 10Base-T /100Base-TX CAT5 (twisted pair) Ethernet LAN cables from two network ports. Cables may be shielded or unshielded. It is important to realize that the two ports are connected to an embedded network switch. The PACSystems RX7i has only one IP address. There is no separate IP address for each port.
The two Ethernet ports automatically detect whether the Ethernet connection is crossover (to a Hub or Switch) or direct (to another node) and automatically connect. This eliminates the need for crossover cables when connecting directly from the port(s) to a hub or a switch.
Ethernet Functional Compatibility：
| Subject | Description |
| RX7i Does Not Support SRTP Client ("Channels") | The Ethernet Interface does not support the SRTP Client operation ("SRTP Channels") that was provided in the Series 90-70 Ethernet Interface (IC697CMM742). |
| SRTP and EGD Performance Differs from Series 90-70 |
SRTP and EGD performance in the RX7i differ slightly from the Series 90-70. Each RX7i Ethernet Interface supports a greater number of SRTP connections and EGD exchanges. Please also note that the RX7i currently has several SRTP and EGD operational restrictions when compared to the Series 90-70. When migrating Series 90-70 Ethernet applications to the RX7i |
| Series 90-70 LAN Interface Module (IC697CMM742) Not Supported by RX7i | Please note that the Series 90-70 LAN Interface Module (IC697CMM742) is not supported by the RX7i and should not be placed in an RX7i rack. The RX7i CPU contains an embedded Ethernet Interface. If additional Ethernet Interfaces are required, the RX7i Ethernet Module (IC698ETM001) should be used. |
To avail our best deals for IC698ETM001, contact us and we will get back to you within 24 hours.