GE IC697MDL750 32-Point Output Module

The 24/48 Volt DC 0.5 Amp Output Module IC697MDL750 for the Programmable Logic Controller (PLC) provides 32 output points in four isolated groups of 8 points each.

IC697MDL750 provides a high degree of inrush current which makes the outputs suitable for a wide range of loads which have such characteristics.LED indicators which give the ON-OFF status of each point on the logic (PLC) side of the circuit are located together at the top of the module.

The module is mechanically keyed to ensure correct replacement with a similar type in the field. I/O references are user configurable without th

Configuration is done using the configuration function of the MS-DOS or Windows programming software running on Windows 95 or Windows NT over Ethernet TCP/IP or through the SNP port. The Programming Software configuration function is installed on the programming device. The programming device can be an IBM XT, AT, PS/2 or compatible Personal Computer.

Output Characteristics:

The 24/48 Volt DC 0.5 Amp Output Module is compatible with a wide variety of load devices, such as:

Solenoids

Motor starters

Indicators

The rating of 0.5 amp per point applies to the longterm current capacity of each point. Because of overall heat dissipation within the module, the maximum current for each group of 8 outputs is limited to 2 amperes.

Each output on this module is capable of transiently conducting a surge current that is much greater than its long-term current rating. The rate at which such surges can be repeated depends on the current rating of the device and the duty cycle (percent of time the device is ON).

For typical incandescent devices operating at a 50% duty cycle, the following repetition rates apply.

Fault Mode Selection:

The module can be configured from the programmer so that output points assume one of two states in response to certain operating or default conditions.

Maintain existing output state

Turn outputs OFF

Module Mechanical Keying:

This module includes a mechanical key that prevents inadvertent substitution of one module type for another in a given slot. The key fits a uniquely shaped area on the board below the connector. The key is included with each module.

When the module is first installed, the key latches onto the backplane center rail. When the module is extracted, the key remains in the center rail, configuring the slot to accept only identical module types.

If it is necessary to change the module location in the rack after the key has been latched onto the center rail of the rack, the key can be removed by pushing it upward to unhook the latch while pulling it off the rail. It may then be reinserted onto the module and the module inserted into the rack in the desired location. Note: Only the power supply can be placed in the leftmost rack position.

Removing an I/O Module:

The instructions below should be followed when removing an I/O modulefrom its slot in a rack.

Grasp the board firmly at the top and bottom of the board cover with your thumbs on the front of the cover and your fingers on the plastic clips on the back of the cover.

Squeeze the rack clips on the back of the cover with your fingers to disengage the clip from the rack rail and pull the board firmly to remove it from the backplane connector

Slide the board along the card guide and remove it from the rack.

To avail our best deals for IC697MDL750 contact us and we will get back to you within 24 hours.