IC697CPM915 GE Fanuc PLC Processor

IC697CPM915 Central Processing Unit (CPU) is a single slot programmable controller CPU that allows floating point calculations. The CPM915 is programmed and configured by MS-DOS or Windows-based programming software to perform real-time control of machines, processes, and material handling systems. It communicates with I/O and smart option modules over a rack-mounted backplane (IC697CHS750, 782, 783, 790, 791) by way of the VME C.1 Standard format.

Supported option modules include all IC697 LAN interface modules, several Coprocessor modules, Bus Controller for IC660/IC661 I/O, Communications module compatible computer to the serial port of the module, and running the Loader software included with the firmware floppy disk.

Features:

Single slot CPU

Provides 1 Mbyte of battery-backed memory in the same slot

Supports floating-point calculations

12K inputs and outputs (any mix)

Up to 8K analog I/O

0.4 microseconds per boolean function

32 MHz, 80486DX microprocessor

Supports IC660/IC661 and IC697 I/O)

Programmed by MS-DOS or Windows software products running on Windows 95 or Windows NT over Ethernet TCP/IP or through the SNP port.

Configurable data and program memory

Battery-backed calendar clock

Three-position operation mode switch

Password-controlled access

Remote programmer keyswitch memory protection

Four status LEDs

Software configuration (No DIP switches or jumpers)

Reference information inside the front door

In-system upgradable firmware

Installation:

It is the responsibility of the OEM, system integrator, or end user to properly install the PLC equipment for safe and reliable operation. Product manuals provide detailed information about installation, startup, and proper use of the PLC equipment. The installation manual, shipped with your PLC programming software, describes how to properly install the equipment. If the PLC installation must comply with supported standards, such as FCC or CE Directives, please refer to the Installation Requirements for Conformance to Standards, shipped with the PLC programming software, for additional guidelines.

Installation should not be attempted without referring to the applicable programmable controller hardware installation manual.

Connect the battery to either of the battery connectors on the module.

Put the toggle switch in the STOP position.

Put the keyswitch in the Memory Protection OFF position.

Make sure that the rack power is off.

Install the CPM 915 module in slot 1 of rack 0.

Turn on the power

The module should power up, and the top LED should blink. When the diagnostics have completed successfully, the top LED stays on and the second and third LEDs are off. The fourth LED is off if the key switch is in the OFF position. The CPU is now ready to be programmed (if connected d parallel, the CPU can be programmed regardless of key position).

After the program has been verified, the toggle switch may be moved to the appropriate operation mode position. The LEDs indicate the position of the toggle switch, memory protection status, and the state of the program.

Removing a Module:

The instructions below should be followed when removing a module from its slot in a rack.

Grasp the board firmly at the top and bottom of the board cover with your thumbs on the front of the cover and your fingers on the plastic clips on the back of the cover.

Squeeze the rack clips on the back of the cover with your fingers to disengage the clip from the rack rail and pull the board firmly to remove it from the backplane connector.

Slide the board along the card guide and remove it from the rack.

To avail our best deals for IC697CPM915, contact us and we will get back to you within 24 hours.