EPRO MMS 6312 Dual Channel Rotational Speed Monitor

Manufacture

EPRO

Model

Part Number

Description

MoOrigin

Germany

Dimension

24*17*6cm

Weight

0.23kg

Each channel can and must be individu-ally configured with the relevant confi.guration software. Measuring modes canbe configured via an externally connected laptop(RS 232 connector on thefrontpanel of the module) or via theRS 485 communication bus, Measuringmodes can be changed at any time during operation.

Available operating and measuringmodes:

Speed measurement with each channel:

Forward or backwards speed measurement with pulse sensors / trigger wheelswith 1 to 255 trigger marks and a fre.quency of max. 20 kHz.

Measures pulses within a time windowof 5 to 10 ms with a reaction time of26 ms or number of,pulses during part ofa revolution or max, 1 revolution (auto.matic tracking),

or measures and processes speed fromnummber of pulses per one revolutionoutput: analogue output proportional tothe speed,

or analogue output with splitted range(different sensitivities for different partsof the range),

or analogue output with enlarged range(higher sensitivity for only a part of thetotal range)and standard rectangularTTL pulses,

or speed measurements with redundanttransducers(i out of two)with bothchannels for one measurement.

Key-pulse detection with each channel:

Either with one key mark on the shaft(with defined phase relation)or withmultiple key marks with max. 255 marksper revolution,

output: standard negative or positive rectangular key puis of 1 ms duration

Standstill detection with each channel:

Detects standstill of trigger wheels with1 to 255 trigger marks:
Measures time between two pulses in aconfigurable range of 1 to 1700 s;

backwards/forwards detection.

Both channels in combined use:

Detects the direction of a rotation withtwo trigger marks of which one is phase.shifted.
Detects a difference between thespeed of two trigger wheels:

Difference adjustable in number of RPM

For each channel two separately adjustabie alarm levels are available which can be operated in the following different modes:

increasing or decreasing measuring level; with or without latching.

If the complete module is used in asingle channel or if both channels are used in a combined mode all available 4 alarm outputs may be used with that channel.

The alarm output functions can be blocked by the channel clear / circuit fault function or by an extemal input.

Adjustable ranges:     5...100 % fsd.

Resolution and reproducebility.

           1 %6o of fsd
Delay time:
           configurable betwen 0...25.5 s

Switching hysteresis:
           configurable

Outputs: via galvanically separated, potential free optocouplers on the rear strip connector.

Two independent input pulse sockets:

identical to the transducer pulse input rate, available via SMB sockets; one for each channel.
Range:        0...4.096 V (reduced by a factor of 0.15)

Load:          >10 kOhm

Frequency range:       0...20 kHz

Two independent output pulse sockets:

Standard, rectangular TTL Pulse; pulse input rate identical to the transducer, available via SMB sockets; one for each channel.
Range:       0...+5 V (TTL), open and short-circuit proof

Load:         >10 kOhm

Frequency range:        0..20 kHz

2 green LED`s:

Indicate "channel clear" separately for channel 1 and channel 2.

4 yellow LED`s:

Indicate the status of the 4 limit outputs.

1 Mini-DiN diode type socket:

as input for the configuration cable RS 232 communication interface.

Handle:

To pull out or insert module with identification labelling facility.