3500/42E 285691-01 Vibration Monitor

3500/42E 285691-01 Vibration Monitor is a 4-channel monitor that accepts input from proximity and seismic transducers, conditions the signal to provide various vibration and position measurements, and compares the conditioned signals with user-programmable alarms.

The user can program each channel of the 3500/42E 285691-01 using the 3500 Rack Configuration Software to perform any of the following functions:

• Radial Vibration

• Thrust Position

• Differential Expansion

• Shaft Absolute

• Eccentricity

• Acceleration

• Velocity

3500 ENCORE series is available in two configurations:

3500 ENCORE Rack Upgrade: In this configuration, the 3500/42E is installed as part of a 3500 ENCORE upgrade of a 3300 Monitor System, where the 3300 chassis and IO remain in place. When used in a r, rack upgrade, the monitor is limited to two channels and uses the pre-existing 3300 series IO Module and the relays located on the 3300 series IO.

3500 ENCORE System: In this conf, there will be a 3500 ENCORE System Rack with 3500 ENCORE IO modules. 3500/42Es that are used in a 3500 ENCORE rack have all four channels available. Monitor channels are programmed in pairs and can perform up to two of the monitoring functions at a time. Channels 1 and 2 can perform one function, while channels 3 and 4 perform another (or the same) function. Monitors in 3500 ENCORE Systems use a logic programmable Relay Module to drive alarm relays.

The primary purpose of the 3500/42E monitor is to provide:

1. Machinery protection by continuously comparing monitored parameters against configured alarm setpoints to drive alarms.

2. Essential machine information for both operations and maintenance personnel.

Each channel, depending on configuration, typically conditions its input signal to generate various parameters called "static values". The user can configure Alert setpoints for each active static value and Danger setpoints for any two of the active static values.

Ordering Information:

The 3500/42E Module requires the following (or later firmware and software revisions:3500/01 Software – Version 4.6

Ordering Options:

Spares：

285691-01  3500/42E Proximitor/Seismic Monitor

289837-01  Proximitor/Seismic I/O Module

287199       3500/42E Vibration Monitor connector shunt

287546-01  3500/42E Monitor Manual

287199       Jumper, 18 Pin, 2 x 9