MVI56E-MNET ProSoft TCP/IP Interface Module

MVI56E-MNET Features:
Protocol support: Supports Modbus TCP/IP protocol, allowing the ControlLogix system to act as a MODBUS host or client.
Backward compatibility: Shares ladder logic and module configuration files with existing MVI56 Modbus TCP/IP communication modules in the field for easy upgrades.
Easy configuration: Add-on instructions provide fast and simple setup, tightly integrated with RSLogix 5000.
Web server: Built-in Ethernet port provides a web server for local access to documentation, module status, firmware updates, etc.
Auto-discovery: Supports ProSoft discovery service to locate the module on the network and assign a temporary IP address for easy configuration.
Diagnostic function: Supports LED scrolling diagnostic display with a 4-character alphanumeric display that can display alarm data, processor, and network communication status, etc.

Installing the Module in the Rack：

If you have not already installed and configured your ControlLogix processor and power supply, please do so before installing the MVI56-MNET module. Refer to your Rockwell Automation product documentation for installation instructions.

After you have checked the placement of the jumpers, insert MVI56-MNET into the ControlLogix chassis. Use the same technique recommended by Rockwell Automation to remove and install ControlLogix modules.

1 Turn power OFF.

2 Align the module with the top and bottom guides, and slide it into the rack until the module is firmly against the backplane connector.

3 With a firm but steady push, snap the module into place.

4 Check that the holding clips on the top and bottom of the module are securely in the locking holes of the rack.

5 Make a note of the slot location. You must identify the slot in which the module is installed in order for the sample program to work correctly. Slot numbers are identified on the green circuit board (backplane) of the ControlLogix rack.

6 Turn power ON.

Connecting your PC to the Module：

With the module securely mounted, connect your PC to the Configuration/Debug port using an RJ45-DB-9 Serial Adapter Cable and a Null Modem Cable.

1 Attach both cables as shown.

2 Insert the RJ45 cable connector into the Configuration/Debug port of the module.

3 Attach the other end to the serial port on your PC.

The MVI56-MNET module requires the following minimum hardware and software components:

ƒ Rockwell Automation ControlLogix™ processor, with compatible power supply and one free slot in the rack, for the MVI56-MNET module. The module requires 800 mA of available power.