Description
Technical Parameters
Product Introduction
The UCVG is a single-slot board using an Intel Ultra Low Voltage Celeron 650MHz processor with 128 MB of flash memory and 128 MB of SDRAM. Two 10BaseT/100BaseTX (RJ-45 connector) Ethernet ports provide connectivity. The first Ethernet port allows connectivity to the UDH for configuration and peer-to-peer communication.
Technical Specifications
|
Manufacture |
General Electric(GE) |
|
Model |
IS215UCVGM06A |
| Part Number | IS215UCVGH1A |
|
Description |
Mark UCVG Controller
|
|
Origin |
USA |
|
Dimension |
30*20*6cm |
|
Weight |
0.35kg |
Product Details
The second Ethernet port is for use on a separate IP logical subnet and can be used for Modbus or private Ethernet Global Data (EGD) network. This Ethernet port is configured through the toolbox. The controller validates its toolbox configuration against the existing hardware each time the rack is powered up.Note A separate subnet address allows the controller to uniquely identify an Ethernet
port. IP subnet addresses are obtained from the Ethernet network administrator (for
example, 192.168.1.0, 192.168.2.0).
UCVG Controller Specifications
|
Item
|
Specification
|
|
Microprocessor
|
Intel Ultra Low Voltage Celeron 650 MHz
|
|
Memory
|
128 MB SDRAM
128 MB Compact Flash Module
256 KB Advanced Transfer Cache
|
|
Operating System
|
QNX
|
|
Programming
|
Control block language with analog and discrete blocks; Boolean logic represented in
relay ladder diagram format. Supported data types include:
Boolean
16-bit signed integer
32-bit signed integer
32-bit floating point
64-bit long floating point
|
|
Primary Ethernet Interface
(Ethernet 1)
|
Twisted pair 10BaseT/100BaseTX, RJ-45 connector:
TCP/IP protocol used for communication between controller and toolbox
EGD protocol for communication with CIMPLICITY* HMI, and Series 90-70 programmable logic controllers (PLCs)
Ethernet Modbus protocol supported for communication between controller and third-party DCS
|
|
Secondary Ethernet Interface
(Ethernet 2)
|
Twisted pair 10BaseT/100BaseTX, RJ-45 connector:
EGD protocol
Ethernet Modbus protocol supported for communication between controller and third-party DCS
|
|
COM Ports
|
Two micro-miniature 9-pin D connectors:
COM1 Reserved for diagnostics, 9600 baud, 8 data bits, no parity, 1 stop bit
COM2 Used for serial Modbus communication, 9600 or 19200 baud
|
|
Power Requirements UCVGH1
|
+5 V dc, 4 A typical, 5.4 A maximum
+12 V dc, less than 1 mA typical
- 12 V dc, less than 1 mA typical
|
|
Expansion site
|
PMC expansion site available, IEEE 1386.1 5 V PCI
|
|
Environment
|
Operating temperature: 0 to 70ºC (32 to 158 ºF)
Storage temperature: -40 to 80ºC (-40 to 176 ºF)
|
|
Note The UCVG controller contains a Type 1 Lithium battery. Replace only with equivalent battery type, rated 3.3 V, 200 mA.
|
|