200-582-916-034 Backplane AC Version

200-582-916-034 Backplane supports power distribution and cooperates with the rack power supply (such as RPS6U rack power supply) to provide stable voltage for the rack itself and all modules installed in the rack to meet the working power requirements of each module. In addition, a power check relay is set at the rear of the rack to indicate whether the installed power supply is working properly, which is convenient for operation and maintenance personnel to understand the power status in time and ensure the operation of the system.

Electrical connectivity: The VM600 system rack's integrated VME backplane provides electrical interconnection between installed VM600Mk2/VM600 modules (power supply, signal processing, input/output, relay and CPUx "rack controller" modules), enabling data transfer and signal sharing between modules.

Bus support: The backplane supports multiple buses of the VM600Mk2/VM600 system, such as Tacho bus, Raw bus and Open collector (OC) bus. These buses are used for data/signal sharing between modules, so that modules with different functions can work together to realize various monitoring and control functions of the system.

Structural design related: Compatible with 19-inch standard racks, there are different specification versions, such as ABE040 and ABE042 system racks are 19-inch system racks with a standard height of 6U and a solid aluminum structure, while ABE056 thin rack is a 19-inch ultra-thin rack with a standard height of 1U, suitable for different installation space and application scenario requirements, providing flexibility for system installation and deployment.

Different models of  power backplanes may vary in the number of specific interfaces, the type and number of modules supported, etc., to accommodate monitoring systems of different sizes and functional requirements.

Common faults of the power backplane and their solutions are as follows:
1. Power failure
Fault phenomenon: The power indicator light is off and the module cannot work properly.
Possible causes: The power input line is open or short-circuited; the power module is damaged; the power distribution circuit on the backplane is faulty.
Solution: First check the power input line to see if it is damaged, broken or short-circuited. If so, repair or replace the line. If the line is normal, use a multimeter to detect the output voltage of the power module. If the voltage is abnormal, replace the power module. If the power module output is normal, check the power distribution circuit on the backplane to see if there are any problems such as component damage and solder joint detachment. If necessary, repair or replace related components.

2.Bus communication failure
Failure phenomenon: The modules cannot communicate normally, the system has data transmission errors or some functions fail.
Possible causes: The bus line connection is poor; the bus interface chip is damaged; the bus drive circuit on the backplane is faulty.
Solution: Check the connection of the bus line to ensure that the interface is firm and there is no looseness, oxidation or other problems. If there are any, re-plug or clean the interface. If the connection is normal, use professional tools to detect the working status of the bus interface chip. If the chip is damaged, replace it with the same model chip. If the chip is normal, further check the bus drive circuit on the backplane to find out if there are any faulty components and replace the damaged components.

3.Module compatibility failure
Failure phenomenon: The newly installed module cannot work properly with the backplane, or the system becomes unstable after upgrading the module.
Possible reasons: The version of the module is incompatible with the backplane; the installation position of the module is incorrect; the configuration parameters of the backplane are not updated.
Solution: Confirm the compatibility of the module and the backplane, check the product manual or consult the manufacturer to ensure that the module is suitable for this model of backplane. Check whether the installation position of the module meets the requirements and whether it is inserted in place. If the module is installed correctly, check the configuration parameters of the backplane and update and set them accordingly according to the requirements of the new module.

Submit your inquiry and we will contact you