3ADT315100R1001 SDCS-POW-4 Power Supply Board

The SDCS-POW-4 is designed for module sizes D5 to D7. It is mounted on the electronic tray. The SDCS-POW-4 generates all necessary auxiliary voltages for the whole drive and the connected options. The power supply on the SDCSPOW-4 is not universal. The power supply automatically adjusts itself to an auxiliary supply voltage of either 230 VAC or 115 VAC.

The 230 VAC or 115 VAC auxiliary supply voltage is connected to connector X99. The input features a hardware filter and a voltage limitation.

To control the main circuit breaker, a relay is needed. To save an additional relay in the cabinet, the DCS800 provides a normally open relay contact integrated on the SDCS-POW-4. This relay output is controlled by digital output 8 and connected to connector X96. The function or signal definition of digital output 8 is done in the firmware by means of parameters.

Connectors X37 and X137 are connected in parallel and used to connect the SDCS-POW-4 to the control board SDCSCON-4 via flat cable.

Connector X14 is used for connection to hard parallel converters.

The SDCS-POW-4 also provides different supply voltages for attached encoders.

With jumpers X3 to 5, it is possible to set the supply voltage to either 5 V, 12 V, 15 V, or 24 V.

To make the different supply voltages available for the encoder connected at the SDCS-CON-,4 set jumper S4 to 10 - 11. Photo of the SDCS-POW-4.

To avail our best deals for 3ADT315100R1001 SDCS-POW-4, contact us, and we will get back to you within 24 hours.