Description
Technical Parameters
Product Introduction
IS420UCPAH2A (UCPA) is a Mark* VIe controller platform that runs application code (control logic). The controller has both integral I/O capabilities and can communicate with external I/O packs through a simplex IONet.
Technical Specifications
|
Manufacture |
General Electric(GE) |
|
Model |
IS420UCPAH2A |
| Part Number | IS420UCPAH2A-C |
|
Description |
Mark Vle Controller with Expanded I/O |
|
Origin |
USA |
|
Dimension |
20*20*8cm |
|
Weight |
0.4kg |
Product Details
The UCPA Mark VIe controller is commercial in design and not intended for use at any time in a residential environment.
The UCPA controller is panel-mounted and includes the following features:
•Controller and I/O in a single module
−Smaller panel footprint with integral I/O
−IONet port for simplex I/O module expansion
•Single 12 V dc power supply, runs at 4 W (low power)
•Can operate in -40 to 70°C ambient temperate range
•No battery or fan
•Cost-effective platform for simplex control and I/O
•Uses ControlST* V05.04 or later with the same ToolboxST* configuration tools across the Mark Controls platform
|
UCPA Specifications
|
|
|
Item
|
UCPA Specfication
|
|
Processor
|
Freescale 3308 processor, 332 MHz, (BPPC-based)
|
|
Memory
|
64 MB RAM
|
|
256 MB onboard flash
|
|
|
32 KB NOVRAM
|
|
|
Temperature/Humidity rating
|
-40 to +70°C (-40 to 158 °F), 5 to 95% relative humidity non-condensing
|
|
Ethernet ports
|
2 Ethernet ports, 10/100 Mbps, ENET1 for UDH, ENET2 for IONet to (maximum 6) distributed I/O
modules
|
|
Ethernet protocols supported
|
Modbus TCP slave, NTP, and other GE proprietary protocols
|
|
Shared IONet
|
Not supported
|
|
10 ms frame period
|
Only supported if not using any distributed I/O packs over IONet
|
|
COM serial port
|
Used to set the network IP address or for maintenance by qualified GE engineer
|
|
Controller and I/O module Redundancy
|
Simplex
|
|
Configuration software
|
ToolboxSTapplication
|
|
Internal operating system
|
QNX (Mark VIe controller)
|
|
Operating voltage
|
9 V to 16 V dc, nominal 12 V dc
|
UCPA Controller Versions
The Mark VIe UCPA controller contains the following components:
•IS400BPPCH2A processor board
•IS400STWCH1A base I/O board
•IS400WEXPH1A expansion I/O board (included with UCPAH2A)
The IS420UCPAH1A includes the IS400STWCH1A (base I/O board) and the BPPCH2A processor board. The IS420UCPAH2A also includes the IS400WEXPH1A expansion I/O board. The WEXP provides the following additional
I/O:
•Six AIs (for a total of 8)
•Two Analog Outputs
•Four DIOs (for a total of 8)