ABB 1MRS050477C MIMIC 1MSC980124 Internal Display

The control functions configured with the Relay Configuration Tool must be associated with object status indicators that are part of the MIMIC configuration picture displayed on the graphic LCD of the HMI. The MIMIC configuration picture is designed with the Relay Mimic Editor. In addition, the editor is used to define the eight programmable LED indicators and the corresponding alarm texts on the front panel, the alarm modes, and the interlocking LED texts.

The MIMIC picture may include a single-line diagram, measured values with units, free texts, etc. The object status indicators (open, closed, undefined) are drawn according to the customer's requirements. Note that the operation of the objects themselves is determined using the Relay Configuration Tool.

The contents of the alarm view are configured with the Relay Mimic Editor by defining the ON and OFF state texts (max 16 characters)

Interlocking LED texts can also be defined in the view illustrated above, but the interlocking LED colours cannot be changed. For the operation of the interlocking LED,

 

The machine terminal is provided with either a fixed display or an external display module. The external display module requires a separate voltage supply from a common source with the main unit (refer to section "Auxiliary voltage" on page 35). For more information about the rated input voltages, A special cable (1MRS120511.002) delivered with the machine terminal is needed for communication between the terminal and the external display panel.

• graphical LCD, with a resolution of 128 x 160 pixels, consisting of 19 rows divided into two windows

• main window (17 rows) providing detailed information on MIMIC, objects, events, measurements, control alarms, and parameters of the terminal

• assisting window (2 rows) for terminal-dependent protection indications and alarms, and general help messages

• three push buttons for object control

• eight freely programmable alarm LEDs with different colours and modes according to the configuration (off, green, yellow, red, steady, blinking)

• LED indicator for control test and interlocking

• Three protection LED indicators

• HMI push-button section with four arrow buttons and buttons for clear [C] and enter [E]

• optically isolated serial communication port

• backlight and contrast control

• freely programmable button [F]

• button for remote/local control (Control position button [R\L])